Cisco DPC2320 DOCSIS - Page 54

Chapter 3 Configuring the DOCSIS Residential Gateway
36 4042831 Rev A
Setup Basic Settings - Fixed CPE IP Assignment Page Description
The following tables provide a description of the fields within the Setup Basic
Settings - Fixed CPE IP Assignment page.
Field Name
Description
MAC Address
The MAC address of the PC or device (for example, a printer) for which
you want to reserve a specific IP address on the network.
Assign to IP
The IP address you assign to the PC or device for which you want to
reserve a specific IP address on the network. Only MAC addresses within
the range of the gateway's DHCP address pool can be reserved with this
feature.
Note: The factory configuration of your gateway sets aside IP addresses
192.168.0.2 through 192.168.0.9 for static IP addresses.
Function Keys
Key
Description
Add Static IP
Adds the Static IP address to the list of assigned IP addresses.
Remove Static IP
Removes the Static IP address from the list of assigned IP addresses.
Restarting the Gateway Modem
Use the Setup Basic Settings - Restart Cable Modem page to restart your cable
modem.
1 Click Restart Modem in the Basic Settings section of the Setup page to access the
Basic Settings - Restart Cable Modem page.
2 Click Reboot Cable Modem to restart the gateway modem.
Note: Restarting your gateway modem does not reset any of the settings.
Setup Basic Settings - Restart Cable Modem Page
The following illustration is an example of the Restart Cable Modem page.