Chapter 3 Configuring the DOCSIS Residential Gateway
Enables/disables the IPsec endpoint mode.
Displays the user-defined tunnel name entered from the VPN Setup
page.
Displays the current connection state (Connected/NOT Connected).
Displays one of the following three keys based on the current tunnel
enable and connection state:
Enable
Connect
Endpoint disabled
Displays Edit or Delete keys used for settings management.
Allows you to create a new tunnel configuration. When you click Add
New Tunnel, the VPN Setup page opens.
Allows you to access the Event Log page. The Event Log page shows a
history of VPN connections and activity in chronological order and also
displays the IP address of both endpoints on the tunnel (local and
remote).
Note: On the Event Log page, pressing the Refresh key updates the
Event Log table to show any changes since the page was loaded. Pressing
the Clear key clears the log table of its current contents and only the most
recent data appears.
To Next Page
Loading...
