EasyManuals Logo

Cisco DPC3212 User Manual

Cisco DPC3212
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Part Number 4021203 Rev A 31
Frequently Asked Questions
Renewing the IP Address on Macintosh Systems
1 Close all open programs.
2 Open your
Preferences folder.
3 Drag the
tcp/ip preferences file to the Trash.
4 Close all open windows and empty the Trash.
5 Restart your computer.
6 As your computer starts, simultaneously press and hold down the
Command
(Apple)
, Option, P, and R keys on your keyboard. Keeping those keys pressed
down, power on your Macintosh but do not release these keys until you hear the
Apple chime at least three times; then, release the keys and let the computer
restart.
7 When your computer fully reboots, click the
Apple icon in the upper-left corner
of the Finder. Scroll down to
Control Panels, and then click TCP/IP.
8 Click
Edit on the Finder at the top of the screen. Scroll down to the bottom of the
menu, and then click
User Mode.
9 Click
Advanced in the User Mode window, and then click OK.
10 Click the Up/Down selector arrows located to the right of the Connect Via
section of the TCP/IP window, and then click
Using DHCP Server.
11 Click
Options in the TCP/IP window, and then click Active in the TCP/IP
Options window.
Note: In some cases, the Load only when needed option does not appear. If it
appears, select the option. A check mark appears in the option.
12 Verify that the
Use 802.3 option located in the upper-right corner of the TCP/IP
window is not selected. If there is a check mark in the option, select the option to
clear the check mark, and then click
Info in the lower-left corner.
13 Is there a Hardware Address listed in this window?
If
yes, click OK. To close the TCP/IP Control Panel window, click File, and
then scroll down to click
Close.
If
no, repeat these instructions from step 6.
14 Reboot your computer.
Q. How do I configure my PC for TCP/IP?
A. If your PC cannot access the Internet after the cable modem is online, it is possible
that your PC did has not been configured for TCP/IP. Follow the appropriate
instructions in this section for your operating system to configure your PC for
TCP/IP.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco DPC3212 and is the answer not in the manual?

Cisco DPC3212 Specifications

General IconGeneral
BrandCisco
ModelDPC3212
CategoryModem
LanguageEnglish

Related product manuals