Configure Wireless Settings
Access Restriction
Allows you to permit or block computers from accessing the wireless
network. The choice that you make here affects the addresses listed on
this page. Choose one of the following options:
Block computers listed below from accessing the wireless network.
Select this option to deny Internet access to the MAC addresses of
the devices you list in the table. All other MAC addresses will be
allowed Internet access.
Permit computers listed below access to the wireless network.
Select this option to allow Internet access only to the MAC
addresses of the devices you list in the table. Any MAC addresses
not listed in the table will be denied Internet access
MAC Address Filter List
The MAC Address Filter List displays users whose wireless access you
want to control. Click Wireless Client List to display a list of network
users by MAC address. From the To Sort by drop-down menu, you can
sort the table by IP Address, MAC Address, Status, Interface, or Client
Name. To view the most up-to-date information, click the Refresh
button.
Wireless > Advanced Settings
Your advanced wireless settings add another layer of security to the wireless
network for your residential gateway. This page is used to set up the advanced
wireless functions. Only an expert administrator should adjust these settings.
Incorrect settings can reduce wireless performance.
Select the Advanced Settings tab to open the Wireless Advanced Settings page.
Use this page to configure the following options:
N Transmission Rate
CTS Protection Mode
Beacon Interval
DTM Interval
Fragmentation Threshold
RTS Threshold
To Next Page
Loading...
Need help?
General
Weight and Dimensions
