Cisco EPC3925 User Manual

46 4021192 Rev B
Configure Wireless Settings
Wireless > MAC Filter
The MAC Filter feature is used to either allow or block access to your wireless LAN
based on the MAC Address of the wireless client devices. The MAC Filter feature,
also known as an access list, can be used to help protect your wireless network from
access by unauthorized users.
Select the MAC Filter tab to open the Wireless MAC Filter page.
Wireless MAC Filter Page Description
Use the descriptions and instructions in the following table to configure the MAC
address filtering for the wireless network for your residential gateway. After you
make your selections, click Save Settings to apply your changes or Cancel Changes
to cancel.
Section
Field Description
MAC Filter
Allows you to Enable or Disable MAC Filtering for the residential
gateway

Cisco EPC3925 Specifications

General

Security algorithms	WEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Wi-Fi	Yes
Modulation	128-QAM, 16-QAM, 32-QAM, 64-QAM, 8-QAM, QPSK
Frequency band	2.4 GHz
Networking standards	IEEE 802.11n
USB 2.0 ports quantity	1
Ethernet LAN (RJ-45) ports	4
Input current	1.5 A
Input voltage	15 V
Input frequency	50/60 Hz
Power requirements	230 VAC
Power consumption (typical)	17 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Voice codecs	G.711, G.723, G.726, G.728, G.729, G.729A

Weight and Dimensions

Weight	430 g
Dimensions (WxDxH)	176 x 145 x 45 mm