Figure 1: Cisco Firepower 1010
The following table lists the features for the Firepower 1010.
Table 1: Firepower 1010 Features
DescriptionFeature
• Common Criteria (CC) on FTD 6.4.x and FX-OS 2.6.x
• Federal Information Processing Standards (FIPS) 140-2 on FTD 6.4.x and FX-OS
2.6.x
• Department of Defense Information Network Approved Product List (DoDIN APL)
• US Government Compliance for IPv6 (USGv6) on FTD 6.4.x
See the "Security Certifications Compliance" topic in the "Appliance Platform Settings"
chapter in the Firepower Management Center Configuration Guide, Version 6.7 for the
instructions on how to enable security certifications compliance.
Security
standards
certifications
1 RUForm factor
Desktop mount
Wall mount (Cisco part number 69-100647-01)
Rack mount (Cisco part number 69-100648-01)
Mounting
Side-to-side
No fan
Airflow
One 4-core Intel CPUProcessor
8-GB DDR4 DRAMMemory
8 GB (internal)Boot partition
Marvell SOHO 88E6390
First supported in Firepower Version 6.5 and ASA Version 9.13.
Note
L2 switch
One Gigabit Ethernet RJ-45 10/100/1000 BaseT
Restricted to network management access; connect with an RJ-45 cable
Management
port
Cisco Firepower 1010 Hardware Installation Guide
2
Overview
Features
To Next Page
Loading...
Need help?
General
