Cisco Firepower 1010 Series User Manual

CHAPTER 2
Installation Preparation
• Installation Warnings, on page 23
• Position the Chassis, on page 25
• Safety Recommendations, on page 26
• Maintain Safety with Electricity, on page 27
• Prevent ESD Damage, on page 27
• Site Environment, on page 27
• Site Considerations, on page 28
• Power Supply Considerations, on page 28
• Rack Configuration Considerations, on page 29
Installation Warnings
Read the Regulatory and Compliance Information document before installing the chassis.
Take note of the following warnings:
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Read the installation instructions before using, installing, or
connecting the system to the power source. Use the statement number provided at the end of each warning
statement to locate its translation in the translated safety warnings for this device.
SAVE THESE INSTRUCTIONS
Warning
Statement 1004—Installation Instructions
Read the installation instructions before using, installing, or connecting the system to the power source.
Warning
Cisco Firepower 1010 Series Hardware Installation Guide
23

Cisco Firepower 1010 Series Specifications

General

Firewall Throughput (AVC)	650 Mbps
Maximum Concurrent Sessions	200, 000
Form Factor	Desktop
Memory	8 GB
Flash Memory	16 GB
Management	Cisco Defense Orchestrator
Power Supply	External
Operating System	Cisco Firepower Threat Defense (FTD)
Interfaces	8 x RJ-45, 2 x SFP