Cisco Firepower 1010 Deployment Guide

HW Revision: 0.6
PCB Serial Number: JAD24040S6L
Power State: Ok
Thermal Status: Ok
Boot Status: OK
Current Task:
firepower#
The output shows two serial numbers. Report the value of Serial (SN) field to your IT department.
Remote Branch Office Deployment of FTD Devices for Management by an
FMC
You can deploy the Firepower Threat Defense (FTD) at a remote branch office using a Firepower Management
Center (FMC) at a central headquarters.
• An administrator at the central headquarters pre-configures the FTD at the CLI, and then sends the FTD
to the remote branch office.
• The branch office administrator cables and powers on the FTD.
• The central administrator completes configuration of the FTD using the FMC.
See the getting started guide for your model for more information:
• Firepower 1010
• Firepower 1100
• Firepower 2100
Firepower Easy Deployment Guide for Cisco Firepower 1000 or 2100 Firewalls
7
Firepower Easy Deployment Guide for Cisco Firepower 1000 or 2100 Firewalls
Remote Branch Office Deployment of FTD Devices for Management by an FMC

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English