Figure 10: Attach the Grounding Lug
Step 6 Make sure that the lug and cable do not interfere with other equipment.
Step 7 Prepare the other end of the grounding cable and connect it to an appropriate grounding point in your site to ensure
adequate earth ground.
What to do next
Install the FIPS opacity shield if necessary. See Install the FIPS Opacity Shield in a Two-Post Rack and Install
the FIPS Opacity Shield in a Four-Post Rack for the procedure.
Install the cables according to your default software configuration as described in the Cisco Firepower 2100
Getting Started Guide.
Rack-Mount and Ground the Chassis
12
Rack-Mount and Ground the Chassis
Ground the Chassis
To Previous Page
Loading...
Need help?
General