Cisco Firepower 2110 Hardware Installation Guide

DescriptionPID
MSP SSD (spare)FPR-MSP-SSD=
Fan tray for the Firepower 2130 and 2140FPR2K-FAN
Fan tray for the Firepower 2130 and 2140 (spare)FPR2K-FAN=
8-port 10-G SFP+ network moduleFPR2K-NM-8X10G
8- port 10-G SFP+ network module (spare)FPR2K-NM-8X10G=
Network module blank slot coverFPR2K-NM-BLANK
Network module blank slot cover (spare)FPR2K-NM-BLANK=
Cable management bracketsFPR2K-CBL-MGMT
Cable management brackets (spare)FPR2K-CBL-MGMT=
Rack-mount brackets (spare)FPR2K-RM-BRKT=
Slide rail kitFPR2K-SLIDE-RAILS
Slide rail kit (spare)FPR2K-SLIDE-RAILS=
Slide rail brackets (spare)FPR2K-RAIL-BRKT=
Power Cord Specifications
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for
connection to the security appliance. The jumper power cords for use in racks are available as an optional
alternative to the standard power cords.
If you do not order the optional power cord with the system, you are responsible for selecting the appropriate
power cord for the product. Using a incompatible power cord with this product may result in electrical safety
hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with
the system.
Only the approved power cords or jumper power cords provided with the security appliance are supported.
Note
The following power cords are supported.
Cisco Firepower 2100 Series Hardware Installation Guide
32
Overview
Power Cord Specifications

Cisco Firepower 2110 Specifications

General

Rack Units	1 RU
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Maximum Concurrent Sessions	2, 000, 000
AVC Throughput	2.2 Gbps
Interfaces	8 x 1G, 2 x 10G SFP+
Power Supply	AC
Dimensions (H x W x D)	1.72 x 17.3 x 16.5 in
Storage Temperature	-4°F to 149°F (-20°C to 65°C)