Figure 9: Firepower 2130 and 2140 Front Panel LEDs
Locator LED
• Off—Locate is off.
• Blue—Locate is on.
The Locator beacon helps you
locate a unit that needs physical
service attention. This feature
is activated in the software.
Note
2Power
• Off—Input power is not detected.
Standby power is off.
• Green, flashing—The system has
detected a power switch toggle event,
and initiated the shutdown sequence.
If the power switch is in the OFF
position, the system powers off after
shutdown is completed. Do not
remove the AC or DC power source
while this LED is blinking so that the
system has time to perform a graceful
shutdown.
• Amber—The system is powering up
(before the BIOS boots). This takes
one to five seconds at most.
• Green—The system is fully powered
up.
1
Cisco Firepower 2100 Series Hardware Installation Guide
13
Overview
Front Panel LEDs
To Next Page
Loading...
Need help?
General
