CHAPTER 2
Installation Preparation
• Installation Warnings, on page 39
• Safety Recommendations, on page 42
• Maintain Safety with Electricity , on page 42
• Prevent ESD Damage , on page 43
• Site Environment , on page 43
• Site Considerations, on page 43
• Power Supply Considerations, on page 43
• Rack Configuration Considerations, on page 44
Installation Warnings
Read the Regulatory Compliance and Safety Information document before installing the security appliance.
Take note of the following warnings:
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Statement 1015—Battery Handling
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the same
or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's
instructions.
Warning
Cisco Firepower 2100 Series Hardware Installation Guide
39
To Next Page
Loading...
Need help?
General
