Cisco Firepower 4100 User Manual

For More Information
• See 10-Gb Network Module, on page 12 for a description of the 10-GB network module.
• See 40-Gb Network Module, on page 13 for a description of the 40-GB network module.
• See 100-Gb Network Module, on page 14 for a description of the two-port 100-Gb network module.
• See Hardware Bypass Network Modules, on page 15 for the location and description of the LEDs,
and the port configurations for the hardware bypass network modules.
• See Install, Remove, and Replace the Network Module for the procedure for removing and replacing
network modules.
10-Gb Network Module
The following figure shows the front panel of the 10-Gb network module (FPR4K-NM-8X10G). The
FPR4K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware
if necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade Guide. See Cisco Firepower
4100/9300 FXOS Compatibility for the software compatibility matrix.
Note
The FPR4K-NM-8X10G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot
be populated at the same time, because of the port row spacing.
Note
Figure 8: FPR4K-NM-8X10G
Overview
12
Overview
10-Gb Network Module

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English