1-13
Cisco IE 4000 Switch Hardware Installation Guide
Chapter 1 Product Overview
Flash Memory Card
Flash Memory Card
The switch supports a flash memory card that makes it possible to replace a failed switch without
reconfiguring the new switch. The slot for the flash memory card is on the front of the switch. The flash
card is hot swappable and can be accessed on the front panel in non hazardous locations only. A cover
protects the flash card and holds the card firmly in place. The cover is hinged and closed with a captive
screw. This prevents the card from coming loose and protects against shock and vibration.
Note For more information on inserting and removing the flash memory card, see the “Installing or Removing
the Flash Memory Card (Optional)” section on page 2-6.
Note The replacement SD card part number is SD-IE-1GB.
Rear Panel
The rear panel of the switch has a latch for installation on a DIN rail. See Figure 1-5. The latch is spring-
loaded to move down to position the switch over a DIN rail and return to the original position to secure
the switch to a DIN rail.
Figure 1-5 Cisco IE 4000 Switch Rear Panel
Management Options
The switch supports these management options:
To Next Page
Loading...
