Cisco IE-4000-8T4G-E - Page 26

2-8
Cisco IE 4000 Switch Hardware Installation Guide
Chapter 2 Switch Installation
Connecting to Power
Supported Power Supplies
The supported power supplies are listed below.
Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter
You install the power converter on a DIN rail, wall, or rack as you would a switch module.
Warning This equipment is supplied as “open type” equipment. It must be mounted within an enclosure
that is suitably designed for those specific environmental conditions that will be present and
appropriately designed to prevent personal injury resulting from accessibility to live parts. The
interior of the enclosure must be accessible only by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards.
Statement
1063
Caution To prevent the switch assemble from overheating, there must be sufficient spacings as explained under
Appendix 2, “Installation Guidelines”, between any other switch assembly.
Table 2-1 Supported Power Supplies
PWR-IE65W-
PC-DC
PWR-IE65W-
PC-AC
PWR-IE170W
-PC-DC
PWR-IE170W
-PC-AC
PWR-IE50W-
AC-IEC
PWR-IE50W-
AC
Current DC-DC AC-DC DC-DC AC-DC AC-DC AC-DC
Input
18-60 VDC/4.3
Amp
110/220 VAC
and 88-300
VDC
10.8-60
VDC/23 Amp
110/220 VAC
and 88-300
VDC/2.1 Amp
110/220 VAC 110/220VAC
and 88-300
VDC
Output
54VDC/1.2
Amp
54VDC/1.2
Amp
54VDC/3.15
Amp
54VDC/3.15
Amp
24VDC/2.1Am
p
24 VDC /
2.1Amp
Dimensions
5.9 in H x
2.1 in. W x
4.9 in. D
5.9 in. H x
2.1 in. W x
4.9 in. D
5.93 in (149.8
mm) H x 4.47
in. (113.5 mm)
W x
5.7 in. (144.7
mm) D
5.93 in. (150.6
mm) H x
3.72 in. (94.5m
m) W x
5.6 in. (142.2m
m) D
5.8 in. H x
2 in. W x
4.4 in. D
5.8 in. H x
2 in. W x
4.4 in. D
Usage
Designed for up
to 25W of POE
load
Designed for up
to 25W of POE
load
Designed for up
to 8 POE ports
or 123W of
POE power.
Designed for up
to 8 POE ports
or 123W of
POE power.
No POE
support.
No POE
support.