Cisco Linksys RE1000 Getting Started

8
Getting Started
RE1000 Range Extender
Connecting with the Wi-Fi Protected Setup Button
Use this method if your router or access point has a Wi-Fi Protected Setup
button.
1. Click or press the Wi-Fi Protected Setup button on the extender.
2. Click the Wi-Fi Protected Setup button on the router’s Wi-Fi Protected
Setup screen (if available), OR press and hold the Wi-Fi Protected Setup
button on the router for one second. When the connection is complete,
the Wi-Fi Protected Setup light on the extender is continuously lit.
3. If you used the extender’s Wi-Fi Protected Setup screen, click OK in that
screen within two minutes.
Connecting with the range extender’s PIN
The Wi-Fi Protected Setup PIN (Personal Identification Number) can be found
on the product label of the extender. You can use this method only if your
router’s administration utility has a Wi-Fi Protected Setup menu.
1. Enter the extender’s PIN into the appropriate field on the router’s Wi-
Fi Protected Setup screen, then click Register. When the connection is
complete, the Wi-Fi Protected Setup light on the extender is continuously
lit.
2. Click OK.
Connecting devices to your network through the
extender
If you have network devices, such as wireless printers, that support Wi-Fi
Protected Setup, then you can use Wi-Fi Protected Setup to connect them to
your wireless network. Choose from the methods below to connect the device
to your network.
NOTE
Wi-Fi Protected Setup configures only one client device at a time.
Repeat the instructions for each client device that supports Wi-Fi
Protected Setup.

Cisco Linksys RE1000 Specifications

General

Wireless Standard	802.11n
Wireless Speed	Up to 300 Mbps
Frequency Band	2.4 GHz
Ethernet Ports	1 x 10/100 Mbps
Security Features	WEP, WPA, WPA2
Antennas	2 internal
Operating Humidity	10% to 85% Non-condensing
Storage Humidity	5% to 90% Non-condensing
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)