Cisco Linksys SFE2000 User Manual

21
Chapter 3: Connecting the Switch
Configuring Units and Ports
Linksys One Ready Communications Solution
Chapter
3
Setting the Unit’s Operational Mode
Use the GUI to set the unit’s operational mode to standalone or stack. This configuration
takes effect after the next reboot.
Configuring the Stack Master and Unit ID
Stack Management
The Stack Management Page allows network managers to either reset the entire stack or a
specific device. Device configuration changes that are not saved before the device is reset
are not saved. If the Stack Master is reset, the entire stack is reset.
To open the Stack Management Page:
1.
Click System > System Management > Stack Management. The Stack Management Page
opens:

Cisco Linksys SFE2000 Specifications

General

Brand	Cisco
Model	Linksys SFE2000
Category	Network Router
Language	English