Need help?Do you have a question about the Cisco Linksys SGE2010P and is the answer not in the manual?
General| PoE | Yes |
|---|---|
| Switching Capacity | 20 Gbps |
| Forwarding Capacity | 14.88 Mpps |
| MAC Address Table Size | 8K entries |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| Humidity | 10% to 90% non-condensing |
| Power Supply | Internal |
| Device Type | Managed Switch |
| Jumbo Frame Support | Yes, up to 9216 bytes |
| Security Features | RADIUS, port security |
| Management | Web-based, CLI, SNMP |
| Form Factor | Rack-mountable |
| Operating Temperature | 32 - 104 °F (0 - 40 °C) |
| Storage Temperature | -4 to 158 °F |
| Ports | 10 Gigabit Ethernet ports (10/100/1000 Mbps) |
Illustrates network setup, cabling distances, and physical connection instructions.
Details establishing a console connection using HyperTerminal for switch configuration.
Accesses screens for managing system information, settings, accounts, and security.
Allows viewing and modifying port settings, including speed, duplex, and flow control.
Configures the switch's operating mode (Layer 2 or Layer 3) and stacking mode.
Explains how to access and connect to the switch using a web browser.
Describes supported Layer 2 VLAN features and Layer 3 routing capabilities.
To Next Page