SGE2010/SGE2010P Administration Guide 48
System Mode (Layer 2 / Layer 3) Selection
Using the Console
To configure the PoE settings:
1. Select Edit.
2. Proceed as needed:
a. Press the down a
rrow key to scroll down through the list of ports.
b. Press the right
arrow key to move the cursor from one field to the next within a row.
c. To change a setting, move the cursor to the field, and then press the Spac
e Bar until the
desired setting appears.
3. Press the Esc ke
y to move the cursor to the Action list.
4. Select Sav
e to save your settings
5. When the Oper
ation complete message appears, press the Esc key to move the cursor to the
Action list.
System Mode (Layer 2 / Layer 3) Selection
You can use the System Mode Selection screen to specify whether the Ethernet switch is
operating in Layer 2 or Layer 3 mode. You can also configure stacking mode from this screen.
To open this screen:
From the S
witch Main Menu, pr
ess 4. System Mode.
Field Settings
Priority Low, High, or Critical
Enable Enable or Disable
To Next Page
Loading...
