13
Chapter 6: Connecting the Wireless-B Ethernet Bridge for Network Use
Wireless-B Ethernet Bridge
Chapter 6: Connecting the Wireless-B Ethernet Bridge for
Network Use
1. After configuration, unplug the power cable from the electrical outlet, and unplug the Ethernet network cable
from the PC, hub, or switch.
2. Plug the Ethernet network cable into the RJ-45 port on the Ethernet-ready network device you wish to add to
the wireless network.
3. Plug the power cable into a local electrical outlet.
The installation of the Wireless-B Ethernet Bridge is complete.
If you want to use the Bridge’s Web-based Utility, refer to “Chapter 7: The Wireless-B Ethernet Bridge
Web-based Utility.”
Note: If you do not have an active connection
to the Ethernet-ready network device, then
change the position of the X-II switch.
To Next Page
Loading...
