Cisco Linksys WRT400N - Page 5

4
Telstra
Telstra is a service used in
Australia and New Zealand
only. If you are using an HBS
connection, check with your ISP
for setup information.
L2TP
L2TP is a service used in Israel
only. If you are using\ an L2TP
connection, check with your ISP
for setup information.
5. After you have entered your Internet Connection Type settings, click
Save Settings.
NOTE: You should congure wireless security to help protect your
wireless network. To congure wireless security, select the security
method you want to use on the Wireless > Wireless Security screen.
For detailed conguration information, refer to the utility’s online
help.
6. Power off the broadband modem, computers, and network devices
and then power them on again so that the network devices obtain the
Router’s new settings.
7. Open a web browser from any computer. In the browser’s Address field,
enter www.linksysbycisco.com/registration and press Enter. The
installation is now complete.
Telstra
L2TP