35
Chapter 5: Configuring the Wireless-G Broadband Router
The Administration Tab - Management
Wireless-G Broadband Router with SRX400
Location. Enter the location of the Router. For example, you could include the name of the building, floor number,
and room location, such as Head Office - Floor 5 - Networking 3.
Get Community. Enter the password that allows read-only access to the Router’s SNMP information. The default
name is public.
Set Community. Enter the password that allows read/write access to the Router’s SNMP information. The default
name is private. A name must be entered in this field.
SNMP Trap-Community. Enter the password required by the remote host computer that will receive trap
messages or notices sent by the Router.
SNMP Trap-Destination. Enter the IP address of the remote host computer that will receive the trap messages.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel
Changes to cancel your changes.
UPnP
UPnP. UPnP allows Windows XP and Windows Me to automatically configure the Router for various Internet
applications, such as gaming and videoconferencing. To enable UPnP, check the Enable radio box. Because
allowing this may present a risk to security, this feature is disabled by default.
Multicast
Multicast Pass Through. Multicasting allows for multiple transmissions to specific recipients at the same time.
If multicasting is permitted, then the Router will allow IP multicast packets to be forwarded to the appropriate
computers. Select Enable to allow multicasting, or Disable to disable this feature.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel
Changes to cancel your changes.
To Next Page
Loading...
Need help?
General
