Cisco MCU24 - Page 4

Contents
iv
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
OL-11897-01
CHAPTER 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU 2-1
Physical Description of the Cisco Unified Videoconferencing 3515 MCU 2-1
Preparing to Install the 3515 MCU 2-2
Verifying the Package Contents of the 3515 MCU 2-3
Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack 2-4
Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration 2-5
Connecting to a PC 2-5
Setting the IP Address 2-6
Connecting the Cisco Unified Videoconferencing 3515 MCU Unit to the LAN 2-8
Video Processing Module Initial Configuration for the 3515 MCU 2-8
Accessing the Video Processing Module Main Menu 2-8
Setting the IP Address 2-9
Setting Ethernet Speed and Duplex Parameters 2-9
Changing the Configuration Software Password 2-10
Changing the Security Level 2-11
Pointing the EMP to the Controlling Cisco Unified Videoconferencing 3515 MCU 2-11
Changing Advanced Configuration Settings 2-12
Saving Network Configuration Settings 2-13
Managing and Monitoring the Cisco Unified Videoconferencing 3515 MCU Unit 2-13
SNMP Management 2-13
Local Port Monitoring Connections 2-13
Performing Software Upgrades 2-14
Accessing the Cisco Unified Videoconferencing 3515 MCU Administrator Interface 2-14
Registering the Online Help for the 3515 MCU 2-15
Netscape Navigator Users 2-15
CHAPTER 3 Using the Cisco Software Upgrade Utility 3-1
Introduction 3-1
Launching the Cisco Software Upgrade Utility 3-1
Upgrading Software 3-2
CHAPTER 4 Cisco Unified Videoconferencing 3515 MCU Cable Connections and Pin-outs 4-1
Unit RS-232 9-Pin Serial Port on the 3515 MCU 4-1
RJ-45 8-Pin IP Network Port on the 3515 MCU 4-2
CHAPTER 5 Cisco Unified Videoconferencing 3515 MCU Technical Specifications 5-1
Technical Specifications Table for the 3515 MCU 5-1