Cisco MX200G2 - Commands

In-Room Control on Touch10
for Cisco TelePresence
MX200 G2, MX300 G2,
MX700, MX800,
SX10, SX20, SX80
Collaboration Endpoint
software version CE8.2
D15358.02 - JULY 2016
www.cisco.com
© 2016 Cisco Systems, Inc.
All rights reserved.
29
Command reference
This chapter includes syntax and semantics for events, commands,
and statuses, that are used with the user interface extensions.
Refer to the API guide to find descriptions of all configurations,
commands, and statuses. Go to
http://www.cisco.com/go/sx-docs for SX Series,
http://www.cisco.com/go/mx-docs for MX Series
Then, click Reference Guides > Command References to find the API
guides.
Overview of events, commands and statuses
Events ................................................................................................. 30
UserInterface Extensions Event Pressed.......................................... 30
UserInterface Extensions Event Changed
........................................ 30
UserInterface Extensions Event Released
........................................ 30
UserInterface Extensions Event Clicked
........................................... 30
UserInterface Extensions Widget Action
.......................................... 31
UserInterface Extensions Widget LayoutUpdated
............................ 31
Commands
......................................................................................... 32
UserInterface Extensions Widget SetValue
...................................... 32
UserInterface Extensions Widget UnsetValue
.................................. 32
UserInterface Extensions Clear
........................................................ 32
UserInterface Extensions List
........................................................... 32
Statuses
.............................................................................................. 33
UserInterface Extensions Widget [n] WidgetId
................................. 33
UserInterface Extensions Widget [n] Value
....................................... 33
Table of contents
Introduction
Create a user interface
API for in-room control
Widgets
Command reference
Troubleshooting
Tips and tricks
Examples
Command reference