Cisco MX200G2 - Statuses

In-Room Control on Touch10
for Cisco TelePresence
MX200 G2, MX300 G2,
MX700, MX800,
SX10, SX20, SX80
Collaboration Endpoint
software version CE8.2
D15358.02 - JULY 2016
www.cisco.com
© 2016 Cisco Systems, Inc.
All rights reserved.
32
Commands
UserInterface Extensions Widget SetValue
This command sets the value of the given widget, and the
UserInterface Extensions statuses are updated accordingly. If the
value is out of range, the command returns an error.
USAGE:
xCommand UserInterface Extensions Widget SetValue Value: Value
WidgetId:
WidgetId
where
Value : String (0, 255)
The value of the widget. The range of values depends on the
widget type.
WidgetId : String (0, 40)
The unique identifier for the widget.
UserInterface Extensions Widget UnsetValue
This command empties the value of the given widget, and the
UserInterface Extensions statuses are updated accordingly. The user
interface is notified that the widget is no longer selected.
USAGE:
xCommand UserInterface Extensions Widget UnsetValue
WidgetId:
WidgetId
where
WidgetId : String (0, 40)
The unique identifier for the widget.
UserInterface Extensions Clear
This command deletes all user interface extensions (widgets) from
the video system.
USAGE:
xCommand UserInterface Extensions Clear
UserInterface Extensions List
Use this command to list all user interface extensions (widgets) that
exist on the video system.
USAGE:
xCommand UserInterface Extensions List
Table of contents
Introduction
Create a user interface
API for in-room control
Widgets
Command reference
Troubleshooting
Tips and tricks
Examples
Command reference