In-Room Control on Touch10
for Cisco TelePresence
MX200 G2, MX300 G2,
MX700, MX800,
SX10, SX20, SX80
Collaboration Endpoint
software version CE8.2
D15358.02 - JULY 2016
www.cisco.com
© 2016 Cisco Systems, Inc.
All rights reserved.
43
Control of blinds
You can either use a spinner, or up and down arrows from the Icons
tab in the widget library.
Consider the following strategy:
• Tilt the slides as response to a short press on a direction arrow. If
tilted all the way, move the blinds up or down incrementally.
• As response to a long press on a direction arrow, start moving
the blinds in that direction. They do not stop until all the way up or
down.
• Short press any button in order to stop the movement after a long
press. Then no separate stop button is necessary.
Use a button only to send a signal
A button can be used just to send a signal, without changing the
button’s state or visual appearance.
As an example, use the All lights on button to switch on all lights. Do
not change the button’s color from gray to blue, but update the other
light controls to reflect the true status of the room.
A button that does not change color
(from gray to blue) when used
To Next Page
Loading...
