Cisco NCS 1014 - Remove and Replace the Controller

Figure 3: Removing the PSU
What to do next
Install the Power Supply Units (PSUs).
Remove and Replace the Controller
Use this procedure to remove and replace the controller in the Cisco NCS 1014 chassis.
Step 1 Using a T15 six lobe/slot screwdriver, unfasten the two screws on the controller.
Step 2 Holding the handle with one hand and supporting the controller with the other, gently pull the controller from the slot.
Remove and Replace Cisco NCS 1014 Modules
5
Remove and Replace Cisco NCS 1014 Modules
Remove and Replace the Controller