Need help?Do you have a question about the Cisco UCS S3260 and is the answer not in the manual?
General| Drive Bays | Up to 56 |
|---|---|
| Maximum Storage Capacity | Up to 600 TB |
| Power Supply | Up to 4 hot-plug power supplies |
| Product Type | Storage Server Chassis |
| Supported Drives | SAS, SATA |
| Processors | Up to two Intel Xeon Scalable processors |
| Memory | Up to 1.5 TB DDR4 RAM |
| Power Supplies | Redundant 80+ Platinum power supplies |
| Total Drive Bays | 56 |
| Management | Cisco UCS Manager |
| Compatibility | Cisco UCS system |
| Form Factor | 4U rack |
Describes the front panel features of the Cisco UCS S3260 storage server, including LEDs and buttons.
Details the rear panel features of the Cisco UCS S3260 system, including LEDs and buttons.
Details the locations of replaceable components within the main chassis, server node, I/O expander, and SIOC.
Provides a high-level overview of the system's management and data architecture, relating it to hardware.
Lists the key features of the Cisco UCS S3260 system, including chassis, processors, memory, and storage.
Provides steps for unpacking and inspecting the Cisco UCS S3260 system for damage or missing components.
Covers guidelines, rack requirements, and equipment needed for system installation.
Details the procedure for installing the Cisco UCS S3260 system into a rack, including slide rail installation.
Explains how to install the optional cable management arm for the Cisco UCS S3260 system.
Outlines the initial system setup steps, including networking and IP address configuration.
Describes the location and meaning of front and rear panel LEDs and buttons for system status.
Defines the states of the front-panel LEDs on the Cisco UCS S3260 system.
Defines the states of the rear-panel LEDs and buttons on the Cisco UCS S3260 system.
Explains the internal diagnostic LEDs located in the main chassis and server node.
Covers required equipment and procedures for shutting down the system for component maintenance.
Provides instructions for installing or replacing various system components like drives, fans, and power supplies.
Lists the physical dimensions and weight of the Cisco UCS S3260 storage server.
Details the operating temperature, humidity, altitude, and acoustic noise specifications.
Lists the specifications for the 1050 W AC and DC power supply options.
Lists the supported power cable part numbers, descriptions, and lengths for the server.
Provides information about supported storage controllers for the server nodes.
Details requirements and procedures for integrating the Cisco UCS S3260 with Cisco UCS Manager.
Compares the Cisco UCS C3160 and S3260 systems, highlighting key differences in features and support.
Provides steps to upgrade a Cisco UCS S3260 system from an M4 server node to an M5 server node.
Details the process for upgrading a Cisco UCS S3260 system with two M4 nodes to two M5 nodes.
Explains how to install a second server node or SIOC into an S3260 system with M5 server nodes.
Describes the procedure for migrating from Version 02 SIOC to Version 03 SIOC.
Outlines procedures for migrating from M3 server nodes to M4 server nodes.
To Next Page
