EasyManuals Logo

Cisco UCS S3260 Service Manual

Cisco UCS S3260
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
CHAPTER
2-1
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
2
Installing the System
This chapter describes how to install the system, and it includes the following sections:
Unpacking and Inspecting the System, page 2-2
Preparing for System Installation, page 2-3
Installing the System in a Rack, page 2-5
Initial System Setup, page 2-13
NIC Modes and NIC Redundancy Settings, page 2-19
System BIOS and Cisco IMC Firmware, page 2-20
Note Before you install, operate, or service a system, review the Regulatory Compliance and Safety
Information for Cisco UCS S-Series Servers for important safety information.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Use the statement number provided at
the end of each warning to locate its translation in the translated safety warnings that
accompanied this device.
Statement 1071

Table of Contents

Other manuals for Cisco UCS S3260

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS S3260 and is the answer not in the manual?

Cisco UCS S3260 Specifications

General IconGeneral
Drive BaysUp to 56
Maximum Storage CapacityUp to 600 TB
Power SupplyUp to 4 hot-plug power supplies
Product TypeStorage Server Chassis
Supported DrivesSAS, SATA
ProcessorsUp to two Intel Xeon Scalable processors
MemoryUp to 1.5 TB DDR4 RAM
Power SuppliesRedundant 80+ Platinum power supplies
Total Drive Bays56
ManagementCisco UCS Manager
CompatibilityCisco UCS system
Form Factor4U rack

Related product manuals