Cisco NCS 1014 User Manual

Remove and Replace Cisco NCS 1014 Modules
This chapter describes the procedures to replace Cisco NCS 1014 modules.
All the modular slots in the NCS 1014 chassis should always be populated with respective modules (line-cards,
controller, PSU & fan units). Empty line card slots to be populated with filler modules, which are shipped
with the chassis. The replacement or upgrade of the modules (Online Insertion or Removal, OIR) to be
performed only when the ambient temperature is below 30-degree C. The OIR of modules should be completed
within five minutes to prevent overheating of the components.
Caution
• Remove and Replace the Pluggables in the 2.4T Line Card, on page 1
• Remove and Replace a Line Card, on page 2
• Remove and Replace the Power Supply Unit (PSU), on page 2
• Remove and Replace the Controller, on page 5
• Remove and Replace the Fan Module, on page 6
• Remove and Replace the Solid State Drive (SSD), on page 8
• Wipe Data in Disk Using Secure Erase, on page 10
Remove and Replace the Pluggables in the 2.4T Line Card
Use this procedure to remove and replace the pluggables in the 2.4T DWDM line card.
This procedure is applicable to replacing pluggables in other line cards too.
Note
Remove and Replace Cisco NCS 1014 Modules
1

Cisco NCS 1014 Specifications

General

Brand	Cisco
Model	NCS 1014
Category	Chassis
Language	English