1-25
Cisco Nexus 1000V for Microsoft Hyper-V Installation Guide, Release 5.2(1)SM1(5.2)
OL-30997-01
Chapter 1 Installing the Cisco Nexus 1000V for Microsoft Hyper-V
Installing the VSM Software
Step 2 Choose the server on which the VM is installed in the SCVMM user interface. In the left navigation pane
under VMs and Services > All Hosts, click the Hyper-V server. In the main window, right-click the
virtual machine that you have created, and choose Properties.
Step 3 In the properties file, click Hardware Configuration in the left navigation pane.
Step 4 In the Hardware Configuration panel, choose NetWork Adapter.
Step 5 In the Network Adapter 1 pane on the right, choose Connected to a VM Network.
Step 6 Browse to find the VM network created in an earlier section.
Step 7 Click OK.
Step 8 In the Hardware Configuration pane, under Virtual Switch, choose the logical switch in the Logical
Switch field. For the classification, choose the previously created port profile in the Classification field.
Note If you set the default port profile earlier as outlined in step 8 of the “Creating a Logical Switch in
SCVMM” section on page 1-16 and if you do not select a port classification for the logical switch in this
window, the default port classification is applied to the logical switch.
Step 9 Click OK.
The Cisco Nexus 1000V for Microsoft Hyper-V installation is now complete.
To Next Page
Loading...
