Cisco Nexus 5600 Series - Page 105

Show Commands
show ipv6 pim df
MCR-101
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 pim df
To display information about the designated forwarders (DFs) for IPv6 Protocol Independent Multicast
(PIM6), use the show ipv6 pim df command.
show ipv6 pim df [rp-or-group] [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6 DFs:
switch(config)# show ipv6 pim df
Bidir-PIM6 Designated Forwarder Information for VRF "default"
RP Address (ordinal) RP Metric Group Range
0001::0001 (7)
[0/0] ff00::/8
Interface DF Address DF State DF Metric DF Uptime
* Lo1 0:: Lose [0/0] 00:00:02
switch(config)#
rp-or-group (Optional) RP or group address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.