Cisco Nexus 5600 Series - Page 108

Show Commands
show ipv6 pim interface
MCR-104
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 pim interface
To display information about the enabled interfaces for IPv6 Protocol Independent Multicast (PIM6), use
the show ipv6 pim interface command.
show ipv6 pim interface [brief] [vrf {vrf-name | all}]
show ipv6 pim interface if-type if-number
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6-enabled interfaces:
switch(config)# show ipv6 pim interface
PIM6 Interface Status for VRF "default"
Ethernet2/12, Interface status: protocol-down/link-down/admin-down
IPv6 address: none
PIM6 DR: 0::, DR's priority: ?
PIM6 neighbor count: 0
brief (Optional) Specifies a brief format for display.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
if-type (Optional) Interface type. For more information, use the question mark (?) online
help function.
if-number (Optional) Interface or subinterface number. For more information about the
numbering syntax for your networking device, use the question mark (?) online help
function.
Release Modification
5.0(3)N1(1) This command was introduced.