Cisco Nexus 5600 Series - Page 114

Show Commands
show ipv6 pim route
MCR-110
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 pim route
To display information about IPv6 Protocol Independent Multicast (PIM6) routes, use the show ipv6
pim route command.
show ipv6 pim route {source group | group [source]} [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display PIM6 routes:
switch(config)# show ipv6 pim route
PIM6 Routing Table for VRF "default" - 1 entries
(*, ff30::/32), expires 00:02:33
Incoming interface: Null, RPF nbr 0::
Oif-list: (0) 00000000, timeout-list: (0) 00000000
Immediate-list: (0) 00000000, timeout-list: (0) 00000000
Timeout-interval: 2, JP-holdtime round-up: 3
switch(config)#
source Source address.
group Group address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.