Cisco Nexus 5600 Series - Page 115

Show Commands
show ipv6 pim rp
MCR-111
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 pim rp
To display information about IPv6 Protocol Independent Multicast (PIM) RPs, use the show ipv6 pim
rp command.
show ipv6 pim rp [group] [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6 RPs:
switch(config)# show ipv6 pim rp
PIM6 RP Status Information for VRF "default"
BSR: 0::, uptime: 1d01h, expires: now,
priority: 0, hash-length: 0
Auto-RP disabled
BSR RP Candidate policy: None
BSR RP policy: None
Auto-RP Announce policy: None
Auto-RP Discovery policy: None
RP: 2001:0db8:0000:abcd::0001, (0), uptime: 1d01h, expires: 0.000000,
priority: 0, RP-source: (local), group ranges:
ff1e:abcd:def1::/96
switch(config)#
group (Optional) Group address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.