Cisco Nexus 5600 Series - Page 124

Show Commands
show routing ipv6 multicast clients
MCR-120
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show routing ipv6 multicast clients
To display information about IPv6 multicast routing clients, use the show routing ipv6 multicast clients
command.
show routing ipv6 multicast clients [client-name]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about IPv6 multicast routing clients:
switch(config)# show routing ipv6 multicast clients icmpv6
IPv6 Multicast Routing Client information
Client: icmpv6, client-id: 2, pid: 3742, mts-sap: 282
Shared-memory: icmpv6, wants notifications
Protocol is join-group owner
Join notifications: sent 1, fail 0, ack rcvd 1
Prune notifications: sent 0, fail 0, ack rcvd 0
RPF notifications: sent 0, fail 0, ack rcvd 0
Delete notifications: sent 0, fail 0, ack rcvd 0
Clear mroute notifications: sent 0, fail 0
Add route requests: rcvd 0, ack sent 0, ack fail 0
client-name (Optional) One of the following multicast routing client names:
• m6rib
• icmpv6
• ipv6
• static
• pim6
Release Modification
5.0(3)N1(1) This command was introduced.