Cisco Nexus 5600 Series - Page 123

Show Commands
show routing ipv6 multicast
MCR-119
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show routing ipv6 multicast
To display information about IPv6 multicast routes, use the show routing ipv6 multicast command.
show routing ipv6 multicast [vrf {vrf-name | all}] {{source group} | {group [source]}}
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about IPv6 multicast routes:
switch(config)# show routing ipv6 multicast
IPv6 Multicast Routing Table for VRF "default"
switch(config)#
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
source Source address for routes.
group Group address for routes.
Release Modification
5.0(3)N1(1) This command was introduced.