Cisco Nexus 5600 Series - Page 184

180
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip igmp groups
show ip igmp groups
To display information about IGMP-attached group membership, use the show ip igmp groups
command.
show ip igmp groups [{source [group]} | {group [source]}] [ethernet slot/port | port-channel
channel-number[.sub_if_number] | vethernet veth-id | vlan vlan-id] [vrf {vrf-name | all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines The show ip igmp route command is an alternative form of this command.
This command does not require a license.
source Source IP address.
group (Optional) Multicast IP address of the single group to display.
ethernet
slot/port
(Optional) Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
port-channel
number
(Optional) Specifies the EtherChannel interface and EtherChannel number. The
range is from 1 to 4096.
sub_if_number (Optional) Subinterface number. The range is from 1 to 4093.
vethernet
veth-id
(Optional) Specifies the virtual Ethernet interface. The interface number can be from
1 to 1,048,575.
vlan vlan-id (Optional) Specifies the VLAN. The range is from 1 to 4094.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
6.0(2)N1(1) This command was introduced.