Cisco Nexus 5600 Series - Page 186

182
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip igmp interface
show ip igmp interface
To display information about IGMP on interfaces, use the show ip igmp interface command.
show ip igmp interface {ethernet slot/port | port-channel channel-number[.sub_if_number] |
vethernet veth-id | vlan vlan-id}
show ip igmp interface [brief] [vrf {vrf-name | all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
ethernet
slot/port
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
port-channel
number
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
sub_if_number Subinterface number. The range is from 1 to 4093.
vethernet
veth-id
Specifies the virtual Ethernet interface. The range is from 1 to 1,048,575.
vlan vlan-id Specifies the VLAN. The range is from 1 to 4094.
brief (Optional) Displays one line status per interface.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
6.0(2)N1(1) This command was introduced.
4.1(3) Changed output to include vPC information when IGMP is in vPC mode.