Cisco Nexus 5600 Series - Page 230

226
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip igmp snooping mrouter
show ip igmp snooping mrouter
To display the multicast routers detected by IGMP snooping, use the show ip igmp snooping mrouter
command.
show ip igmp snooping mrouter [vlan vlan-id]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the multicast routers detected by IGMP snooping:
switch(config)# show ip igmp snooping mrouter
Type: S - Static, D - Dynamic, V - vPC Peer Link
Type: S - Static, D - Dynamic, V - vPC Peer Link, I - Internal
Vlan Router-port Type Uptime Expires
20 Vlan20 I 04:16:16 never (down)
switch(config)#
vlan vlan-id (Optional) Specifies a VLAN. The range is from 1 to 3967 and 4048 to 4093.
Release Modification
6.0(2)N1(1) This command was introduced.
4.1(3) Changed output to include vPC information.