Cisco Nexus 5600 Series - Page 252

248
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip msdp mesh-group
ip msdp mesh-group
To configure a Multicast Source Discovery Protocol (MSDP) mesh group with a peer, use the ip msdp
mesh-group command. To remove the peer from one or all mesh groups, use the no form of this
command.
ip msdp mesh-group peer-address name
no ip msdp mesh-group peer-address [name]
Syntax Description
Command Default None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure a mesh group with a peer:
switch(config)# ip msdp mesh-group 192.168.1.10 my_admin_mesh
This example shows how to remove a peer from a mesh group:
switch(config)# no ip msdp mesh-group 192.168.1.10 my_admin_mesh
Related Commands
peer-address IP address of an MSDP peer in a mesh group.
name Name of a mesh group.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip msdp
mesh-group
Displays information about MSDP mesh groups.