Cisco Nexus 5600 Series - ip msdp keepalive

247
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip msdp keepalive
ip msdp keepalive
To configure a Multicast Source Discovery Protocol (MSDP) peer keepalive interval and timeout, use
the ip msdp keepalive command. To reset the timeout and interval to the default, use the no form of this
command.
ip msdp keepalive peer-address interval timeout
no ip msdp keepalive peer-address [interval timeout]
Syntax Description
Command Default The keepalive interval is 60 seconds.
The keepalive timeout is 90 seconds.
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure an MSDP peer keepalive interval and timeout:
switch(config)# ip msdp keepalive 192.168.1.10 60 80
This example shows how to reset a keepalive interval and timeout to the default:
switch(config)# no ip msdp keepalive 192.168.1.10
Related Commands
peer-address IP address of an MSDP peer.
interval Keepalive interval in seconds. The range is from 1 to 60. The default is 60.
timeout Keepalive timeout in seconds. The range is from 1 to 90. The default is 90.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip msdp peer Displays information about MSDP peers.