Cisco Nexus 5600 Series - Page 270

266
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip msdp mesh-group
show ip msdp mesh-group
To display information about Multicast Source Discovery Protocol (MSDP) mesh groups, use the show
ip msdp mesh-group command.
show ip msdp mesh-group [mesh-group] [vrf {vrf-name | all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about MSDP mesh groups:
switch(config)# show ip msdp mesh-group
mesh-group (Optional) Mesh group name.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
6.0(2)N1(1) This command was introduced.