Cisco Nexus 5600 Series - Page 273

269
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip msdp route
show ip msdp route
To display information about the Multicast Source Discovery Protocol (MSDP) Source-Active (SA)
cache, use the show ip msdp route command.
show ip msdp route [{source [group]} | {group [source]}] [asn] [peer peer] [detail] [vrf {vrf-name
| all}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines The show ip msdp sa-cache command is an alternative form of this command.
This command requires the LAN Base Services license.
Examples This example shows how to display information about the MSDP SA cache:
switch(config)# show ip msdp route
source Source address for SA cache information.
group (Optional) Group address for SA cache information.
asn (Optional) Autonomous system (AS) number.
peer peer (Optional) Specifies the IP address of a peer.
detail (Optional) Displays detailed information.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
6.0(2)N1(1) This command was introduced.