Cisco Nexus 5600 Series - Page 327

323
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim border
ip pim border
To configure an interface on an IPv4 Protocol Independent Multicast (PIM) border, use the ip pim
border command. To remove an interface from a PIM border, use the no form of this command.
ip pim border
no ip pim border
Syntax Description This command has no arguments or keywords.
Command Default The interface is not on a PIM border.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure an interface on a PIM border:
switch(config)# ip pim border
This example shows how to remove an interface from a PIM border:
switch(config)# no ip pim border
Related Commands
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim interface Displays information about PIM-enabled interfaces.