Cisco Nexus 5600 Series - Page 328

324
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim bsr bsr-policy
ip pim bsr bsr-policy
To allow the bootstrap router (BSR) client routers to filter IPv4 Protocol Independent Multicast (PIM)
BSR messages that are based on a route-map policy, use the ip pim bsr bsr-policy command. To disable
filtering, use the no form of this command.
ip pim bsr bsr-policy policy-name
no ip pim bsr bsr-policy [policy-name]
Syntax Description
Command Default Disabled
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines You can specify which source addresses to filter messages from with the match ip multicast command
in a route-map policy.
This command requires the LAN Base Services license.
Examples This example shows how to allow the BSR client routers to filter BSR messages:
switch(config)# interface ethernet 2/2
switch(config-if)# ip pim bsr bsr-policy my_bsr_policy
This example shows how to disable filtering:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip pim bsr bsr-policy
Related Commands
policy-name Route-map policy name.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim rp Displays information about PIM RPs.