Cisco Nexus 5600 Series - Page 350

346
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim register-policy
ip pim register-policy
To filter IPv4 Protocol Independent Multicast (PIM) Register messages that are based on a route-map
policy, use the ip pim register-policy command. To disable message filtering, use the no form of this
command.
ip pim register-policy policy-name
no ip pim register-policy [policy-name]
Syntax Description
Command Default Disabled
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines You can use the match ip multicast command in a route-map policy to specify the group or group and
source addresses whose register messages that should be filtered.
This command requires the LAN Base Services license.
Examples This example shows how to enable filtering of PIM Register messages:
switch(config)# ip pim register-policy my_register_policy
This example shows how to disable message filtering:
switch(config)# no ip pim register-policy
Related Commands
policy-name Route-map policy name.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim policy
statistics
register-policy
Displays statistics for PIM Register messages.