347
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim register-rate-limit
ip pim register-rate-limit
To configure a rate limit for IPv4 Protocol Independent Multicast (PIM) data registers, use the ip pim
register-rate-limit command. To remove a rate limit, use the no form of this command.
ip pim register-rate-limit rate
no ip pim register-rate-limit [rate]
Syntax Description
Command Default None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure a rate limit for PIM data registers:
switch(config)# ip pim register-rate-limit 1000
This example shows how to remove a rate limit:
switch(config)# no ip pim register-rate-limit
Related Commands
rate Rate in packets per second. The range is from 1 to 65,535.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim vrf detail Displays information about the PIM configuration.
To Next Page
Loading...
