Cisco Nexus 5600 Series - Page 360

356
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim sg-expiry-timer
ip pim sg-expiry-timer
To adjust the (S, G) expiry timer interval for Protocol Independent Multicast sparse mode (PIM-SM)
(S, G) multicast routes, use the ip pim sg-expiry-timer command. To reset to the default values, use the
no form of the command.
ip pim [sparse] sg-expiry-timer seconds [sg-list route-map]
no ip pim [sparse] sg-expiry-timer seconds [sg-list route-map]
Syntax Description
Command Default The default expiry time is 180 seconds.
The timer applies to all (S, G) entries in the routing table.
Command Modes VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure the expiry interval to 300 seconds for all (S, G) entries:
switch(config)# vrf context Enterprise
switch(config-vrf)# ip pim sg-expiry-timer 300
switch(config-vrf)#
Related Commands
sparse (Optional) Specifies sparse mode.
seconds Expiry-timer interval. The range is from 181 to 57600 seconds.
sg-list
route-map
(Optional) Specifies S,G values to which the timer applies. The route map name can
be a maximum of 100 alphanumeric characters.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim context Displays information about the PIM configuration.