Cisco Nexus 5600 Series - Page 365

361
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim ssm
ip pim ssm
To configure group ranges for Source Specific Multicast (SSM), use the ip pim ssm range command.
To reset the SSM group range to the default, use the no form of this command with the none keyword.
ip pim ssm {range {groups | none} | route-map policy-name}
no ip pim ssm {range {groups | none} | route-map policy-name}
Syntax Description
Command Default The SSM range is 232.0.0.0/8.
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines The match ip multicast command is the only match command that is evaluated in the route map. You
can specify the group prefix to filter messages with the match ip multicast command.
This command requires the LAN Base Services license.
Examples This example shows how to configure a group range for SSM:
switch(config)# ip pim ssm range 239.128.1.0/24
This example shows how to reset the group range to the default:
switch(config)# no ip pim ssm range none
This example shows how to remove all group ranges:
switch(config)# ip pim ssm range none
groups List of up to four group range prefixes.
none Removes all group ranges.
route-map
policy-name
Specifies the route-map policy name.
Release Modification
6.0(2)N1(1) This command was introduced.